This kit includes new rotors, brake pads, and stainless steel brake lines to improve the braking performance of your vehicle.
REAR LOCATION
FACTIONFAB SWEPT SLOT BI-DIRECTIONAL ROTOR PAIR REAR
- Rear location
- Shallow Sharp-edged groves are milled into a high carbon cast iron disc to provide consistent pad contact and maximum friction over repetitive use
- High-carbon content for wear resistance, thermal stability, and cracking resistance
- Bi-directional design, meaning rotors are not side specific
- Symmetric vane castings to increase heat dissipation efficiency and thermal stability
- Double-disc ground, non-directional finish
- Mill balanced for reduced vibration
- Precision machined with run-out spec of no more than .002″, Disc Thickness Variation (DTV) of .0005″
- Fully machined non-friction surfaces for perfect fitment
- Electronically applied E-coating for corrosion resistance
- 400-hour salt spray tested
- Fully coated inside and out
FACTIONFAB F-SPEC REAR BRAKE PADS
- Rear location
- Para-Aramid Composition
- Ideal for auto-x, light track days, or aggressive street driving
- 1300ºF maximum operating temperature to aid in fade resistance
- Excellent modulation and initial bite
- Pre-scorched compound to aid in cold weather modulation
- O.E. gas slots and chamfers ensuring for safe efficient stopping while reducing noise associated with vibration
- Positive molded technology provides safe and reliable stopping performance for the entire service life of the brake pad
- Positive molded technology manufacturing process uses extreme pressure to compress the friction material and drives out any impurities or excess resins found in the brake pad
- Precision cut backing plates ensure correct pad fitment in the caliper body eliminating vibrations and noise under braking
- Mechanically attached application specific pad shims are designed to eliminate noise associated with brake pad vibrations
FACTIONFAB STAINLESS STEEL BRAKE LINES
- Rear location
- PTFE Teflon inner liner to carry the fluid
- Stainless steel woven middle layer for support of the inner liner
- Abrasion-resistant, impact-resistant
- Outer PCV clear abrasion resistant coating to aid in chaffing and protects the inner layers and stress relief at fitting locations
- Each line is 4500psi burst pressure tested
- Stainless steel precision machined fittings for perfect fit and corrosion resistance
- Increased pedal feedback as a result of elimination of soft rubber lines which are prone to swelling and deforming
- 100% model specific for perfect fitment
- Includes hardware
FITMENT NOTE: This is for 2015+ WRX models WITHOUT Eyesight.
