Product Description
DSS Nissan S14 with RB25 (5-Speed) using Syko Mounts / Non-ABS / Steel Driveshaft NISH2SY-S
S14 Non-ABS with RB25 5-Speed using Syko mounts Steel Shaft. This is our steel 1-piece replacement shaft for the 240SX platform. This shaft is about 5lb less than the factory 2-piece and will give the car a faster throttle response due to the fact the hanger bearing is not moving up and down during acceleration. A less expensive alternative to our aluminum shaft, it has been suggested by a few of the drift cars that we sponsor the steel shaft breaks the tires loose quicker than the aluminum. This steel shaft will give you most of the benefits of the aluminum shaft, without the cost.
Please Note: Whether or not the car was equipped with ABS from the factory will change the length of the driveshaft. Be sure to check vehicle before ordering.
Driveshaft Shop Driveshafts are built to handle not only the power of drag and drift cars but also add to the efficiency of these types of racing. Aluminum has been used in drive shafts for years but most people think its just because they are lighter - Were you aware they are more torsional?
By being able to twist more than a steel shaft it will not only make the ride smoother but it will also take some of the harmful shock factor out of the drive train helping to keep up the RPM. This will also help to save most output shafts and other related drive train parts down the line. The aluminum shaft also has a higher resonant frequency than steel (a steel shaft will act as a amplifier of vibration). An aluminum shaft will deaden the vibration due to its characteristics.
Additional Information
| Weight | 42 lbs |
|---|---|
| Dimensions | 54 × 6 × 6 in |
