Product Description
DSS Nissan S14 with RB25 (5-Speed) using Syko Mounts / Non-ABS / Aluminum Driveshaft NISH2SY-A
S14 Non-ABS with RB25 5-Speed (Syko mounts) Aluminum Shaft. This is our single shaft conversion for the 240SX platform. This is a complete 6061-T6 aluminum shaft that is about 1/2 the weight of the factory 2-piece. The shaft features larger, replaceable and greaseable u-joints and can handle about 650WHP. By removing the factory 2-piece shaft and installing a single shaft the car will feel more responsive due to the fact the hanger bearing is not moving up and down during acceleration. Available for most popular motor/trans combinations, if you don’t see yours listed, custom shafts are also available.
Please Note: Whether or not the car was equipped with ABS from the factory will change the length of the driveshaft. Be sure to check vehicle before ordering.
Driveshaft Shop Driveshafts are built to handle not only the power of drag and drift cars but also add to the efficiency of these types of racing. Aluminum has been used in drive shafts for years but most people think its just because they are lighter - Were you aware they are more torsional?
By being able to twist more than a steel shaft it will not only make the ride smoother but it will also take some of the harmful shock factor out of the drive train helping to keep up the RPM. This will also help to save most output shafts and other related drive train parts down the line. The aluminum shaft also has a higher resonant frequency than steel (a steel shaft will act as a amplifier of vibration). An aluminum shaft will deaden the vibration due to its characteristics.
Additional Information
| Weight | 40 lbs |
|---|---|
| Dimensions | 54 × 6 × 6 in |
