Product Description
DSS 2003-2008 G35 Coupe 6 speed Manual 3.25in Carbon Fiber Driveshaft INSH1-C
This is the complete Carbon Fiber Driveshaft for the G35 platform, its weighs less than half as much as the factory 2 piece shaft. It’s made from 3.25″ carbon fiber with billet aluminum ends and is a direct bolt on with no modification required. By removing the factory 2 piece shaft the car will lose the excessive motion caused by the hanger bearing moving up and down when you step on the gas, this will make the car react faster to throttle input and make the car feel more responsive. It is also significantly more torsional than the OE shaft which helps relieve some of the instantaneous shock at launch and between shifts. Rated to over 1000HP.
Driveshaft Shop Driveshafts are built to handle not only the power of drag and drift cars but also add to the efficiency of these types of racing. Aluminum has been used in drive shafts for years but most people think its just because they are lighter - Were you aware they are more torsional?
By being able to twist more than a steel shaft it will not only make the ride smoother but it will also take some of the harmful shock factor out of the drive train helping to keep up the RPM. This will also help to save most output shafts and other related drive train parts down the line. The aluminum shaft also has a higher resonant frequency than steel (a steel shaft will act as a amplifier of vibration). An aluminum shaft will deaden the vibration due to its characteristics.
Additional Information
Weight | 40 lbs |
---|---|
Dimensions | 77 × 6 × 6 in |