Product Description
Antigravity Smart Clamps (For XP1/XP3)
SMART Clamps for the Newly Redesigned models XP-1 and XP-3. Featuring 6 built-in protections to safely jump-start vehicles!
PLEASE NOTE: These Replacement Clamps are for the NEWER models of the MICRO-START XP-1 and XP-3 ONLY, which have a new Thermal Protection feature. They will Not work with the Original/Older version of the XP-1 and XP-3! If you have the older models, go Here.
SMART CLAMPS
These are replacement mini clamps for the NEWER models of the MICRO-START XP-1 and XP-3. These SMART jump-start Clamps have additional safety features built-in for full protection. (Note: the clamps also have a stronger plastic clamp joint where previously it was a metal pin.)
REVERSE POLARITY PROTECTION
Protects from connecting the Smart Clamps in reverse polarity. The clamps will not allow User to Jump Start and will Notify User with RED LED Flashing.
SHORT CIRCUIT PROTECTION
If the Smart Clamps touch or are connected together accidentally the clamps will disconnect immediately and not allow Short-Circuit.
CAUTION: If the BOOST BUTTON is pressed this will BYPASS the safety features of the Smart Clamps. Use CAUTION and make certain Clamps are connected correctly at Battery Terminals BEFORE pressing Boost Button.
REVERSE CURRENT PROTECTION
If the clamps are left on the vehicle, the Reverse Current protection will not allow a Back-Charging into the MICRO-START. In any case we still suggest never leaving the unit connected to a vehicle more than 30 seconds after a Start.
OVER CURRENT PROTECTION
If the Current exceeds 600 amps the Smart Clamps will shut down automatically protecting the unit from damage.
OVER DISCHARGE PROTECTION
When the output voltage of the MICRO-START is less than 10 Volts the clamps will not allow jump starting or further amperage discharge from the clamps.
THERMAL PROTECTION
Protection against over-heating of Clamps due to Over-Cranking of Vehicle which can generate high heat and damage unit. The Smart Clamps will sense high heat and shut off Clamps.
- 1pc SMART CLAMPS (replacement for use with NEWER models of Micro-Start XP-1 and XP-3).
COMPATIBLE WITH:
- XP-1 (New Design)
- XP-3 (New Design)
-
SAFETY NOTES:
- The MICRO-START is for Jump-Starting ONLY through the Jump-Start port!
- Never leave the Micro-Start connected to your vehicle’s battery for longer than 30 seconds, or use in place of your regular battery in your vehicle.
- Do not try to charge the Micro-Start directly from your battery through the jump start port. Severe damage can result!
